Hey Miika,
I attempted to read a 2018 USDM STI the other day. I was unable to get the read procedure to begin. Process immediately failed. Attempted after verifying EcuFlash would communicate both read and flash
Are you able to see if 2018+ is able to be supported?
Thank you
2018+ Support
Moderator: Global Moderator
Re: 2018+ Support
Hi,
Yes that should come available as soon as I have updated communication finished. 2018 is able to flash with Denso CAN protocol but ECU needs to be in bench. Updated communication will use basic iso15765 CAN protocol so it should work with same models as EcuFlash subarucan method..
Yes that should come available as soon as I have updated communication finished. 2018 is able to flash with Denso CAN protocol but ECU needs to be in bench. Updated communication will use basic iso15765 CAN protocol so it should work with same models as EcuFlash subarucan method..